The correct use of stone engraving machine

    Stone engraving manufacturers are currently using stone engraving machines as the most important tool for mechanized production, thus completing the production process of stone carving. However, many of these manufacturers do not use this machine correctly. Today, let me introduce you to the correct use of the engraving machine.
    Anyone who uses an engraving machine knows that the engraving machine is a numerical control machine. Therefore, before using the engraving machine, all the values ​​of the engraving machine should be zeroed. Otherwise, deviations will occur during engraving, and it is impossible to complete the engraving according to the pre-designed trajectory and typesetting.
    Secondly, the running power of the engraving machine is relatively large, so the stone engraving machine manufacturer will design a water pump for the engraving machine, which is used to cool the engraving machine. When the engraving machine is used, the machine will heat up and the pump will cool the machine. Therefore, when using, ensure that the pump can perform normal cooling function. If the temperature in the pump is too high, it is necessary to replace the cold water in time.
    Finally, the engraving machine's knives are not as fast as possible. In fact, the carving of different stones should have the speed of the knives that are not used. Otherwise, the knives rotate too fast, and if the stones are too hard, the problem of broken knives will occur. Therefore, when using, it is best to adjust the speed of some knives, do not let its speed too fast, which causes the problem of broken knives.

Common troubles when operating woodworking engraving machines

    Even if you are a very skilled worker, you should be able to carry out specific analysis on how to use the machine, including how to maintain it after years of disrepair. Sometimes you have to encounter specific problems. When operating the woodworking engraving machine, the workers found that the conventional failure problems were actually many, because the operation was not standardized, or the usual maintenance was not timely.
    First of all, let's pay attention to the most important motor. Due to the long-term use, sometimes it will feel that the motor has no strength or some stuck condition when it is turned. First, do not blindly disassemble, check the circuit, including the motor circuit. Is there a problem with the connection, and if the wire is broken due to disrepair, the wire is short-circuited.
    Secondly, if there is no problem with the wiring and external wiring of the motor, it depends on whether the machine itself is overloaded. Long hours of work will definitely consume the energy of the machine itself. If you find that there is no problem after careful inspection, it is that there is a fault inside the machine, and it must be repaired or repaired in time.
    This type of electronic engraving tools are often used in professional factories or in some large enterprises. When purchasing, they are basically added in batches. Therefore, when selecting woodworking engraving machine manufacturers in the early stage, not only should they be inspected. The quality of the product, but also to sign detailed contract details with the other party, so as to avoid any problems in the machine, resulting in the impact of the entire project efficiency after repair.